Undo commands

Commands to remove part or all of the structure you have built with previous commands.

Reset the interpreter

The reset command replaces the system main or a named system by an empty system. Any defmodule definitions you have made are still remembered. The syntax is

Remove a primitive

The delprimitive command removes the named primitive from the current module. The syntax is

where name is the name of the primitive.

Remove a connection

The disconnect command reverses the effect of a previous connect or nodeconnect command. The syntax is

where block and port, taken together, specify one of the two connected portholes. Note that you can disconnect by specifying either end of a porthole for a point-to-point connection.

Remove a node

The delnode command removes a node from the current module. The syntax is: